October 12, 2021
Richards Manufacturing is an innovator in developing 600-amp termination products for the electrical industry. Richards designed the 600-amp T Body with a built-in load break tap plug, and it has been a helpful addition for technicians. This unit is available in both cold shrink and standard elbow. Richards also offers a choice of compression or shear bolt connector. The shear bolt connector application shortens stacking height in your enclosure by approximately 2¾”.
Cold shrink 600-amp dead break T Body elbows reduce installation time and stress on the technician. Instead of installing a cable adaptor, the CSH uses a stress control mastic, simplifying installation steps and processes.
This product is also available in standard configuration with a cable adaptor. To purchase this product, check our Richards Manufacturing page today!
Meet The Author
Pulling and Jetting/Blowing are the most common ways to deploy fiber optic cables. But each technique can impact a fiber...
Read Full Article >Did you know it takes 7 gigabytes of data per hour to stream an online video? Did you know that 100 million gigabytes of...
Read Full Article >When visiting customers and contractors, we often run across this discussion: "how much water should there be in a fiber...
Read Full Article >CLEAVES-BESSMER-MARIETTI, INC.
255 NW BLUE PARKWAY, SUITE 200, LEE'S SUMMIT, MO 64063
(816) 353-6011
COPYRIGHT © 2022